When you are moving from a carpet that is full of dust and mold to one that is fresh and clean, you have to be aware of the steps in cleaning carpets so that you do not make any mistakes when cleaning. Carpets tend to get dirty in many different ways.
They can be made dirty from the dirt that gets ground into them from day-to-day activities or from the water and stain that gets tracked in on them throughout the years. They can also be kept clean by steam or even shampoo. Regardless of the way they get dirty, though, they need to be properly cleaned so that they are ready for your new home.
The easiest thing to do is to vacuum. Vacuuming keeps your carpet clean as well as helps remove any loose dirt or other things that might be stuck in between the fibers. To keep it clean without completely removing all of the files, though, you need to actually clean the carpet.
There are two main steps in cleaning carpets and they include vacuuming and washing the carpet with water. Vacuuming can be done by hand or in a vacuum cleaner depending on how dirty the carpets are and what type of surface they have. Be sure to give carpets with very thick carpets a good vacuuming.
If you have to do this frequently, you should consider buying a quality vacuum cleaner because this will pay for itself over time. Many people use just water and a sponge to help remove the debris from their carpets, but there are more efficient and effective ways to do this. This Boise-based carpet cleaning company will be more than glad to assist you with their top-notch services.
Start the process of cleaning a carpet with a cleaning solution if you have one handy. Many people choose to mix a little soap into the water and use this to clean their carpets. If you are uncertain about whether or not a cleaning solution will work properly on your type of surface, you may consider using distilled water instead.
This is much easier on surfaces and it is also less costly. Make sure that you rinse the carpet with the cleaning solution well before moving onto the next step. You need to thoroughly scrub the carpet with a scrub brush or power washer if you have one. Use abrasive materials and make sure to keep cleaning in the direction of the fibers.
When cleaning the entire surface of the carpet you want to be sure to go over each piece of carpet and give each piece a good thorough scrubbing. Go over each area of the surface about four times with the scrub brush to ensure you get all of the dirt and grime that you can.
After you have finished with the scrubbing process, take a clean damp sponge and apply some water to help with the drying process. The carpet will dry in a few minutes, but you don’t want to sit on it for too long since you want to get as much water out of it as possible.
Once you have let the carpet dry, you can then move onto the next step of your cleaning process. Make sure you pick up the carpet and gently pat it down until you can see all of the dust particles. Then use an air compressor to completely dry the carpet. It is extremely important to dry the carpet completely before moving onto the next step.
For the third step, you are going to shampoo the carpet and then use a mild detergent to wash the carpet thoroughly. Make sure that the water from the detergent doesn’t run onto the dryer or else it will stain the carpet. It is also important to use plenty of water to help with the drying process since it is very dry.
Once you have washed the carpet, make sure that you thoroughly dry it with a fan. If you follow these simple steps in cleaning carpets, you should notice that it is much easier to remove the stains from the carpet. Carpets can become quite expensive so it is important that you take care of your investment.
By following these steps in cleaning carpets, you will be able to keep your carpet looking new. This will save you money and time in the long run. These steps in cleaning carpets will ensure that you get the best results each time you clean your carpet.
